All notesAbout

Painting or staining a fence: which to choose and how to do it

Spring · November 2026 · about 5 minutes

Sooner or later every Auckland section reaches the same Saturday: the fence has gone grey, patches of green have appeared on the shady side, and a bucket of something needs to be applied. The first decision, paint or stain, shapes everything that follows, from how much scrubbing you do this weekend to how often you will be back with the brush. Neither is wrong. They suit different people and different fences.

Paint or stain: the trade-off

Stain soaks into the grain and wears away gradually instead of flaking. Paint sits on the surface as a film. Paint-maker Resene's technical advice sums up the trade: stain needs fewer coats at first but a fresh coat roughly every 1.5 to 3 summers, whereas paint needs more work up front (primer and two topcoats) and then lasts longer between jobs. OneRoof's guide to prepping and painting a timber fence says a painted fence should hold up for at least seven years, often longer, and that semi-transparent stain wants reapplying about every two years.

That leads to a rule of thumb. If you like doing a quick refresh every couple of years and want to see the grain, stain is forgiving. If you would rather do the hard work once, paint rewards the effort. There is a catch both ways:

That last point is worth a chat over the fence before you buy anything. It is a neighbourly courtesy, and it affects the result.

Prep is most of the work

Almost every guide agrees on the order of jobs:

  1. Check the structure. Tighten loose boards and look for wobbly posts first; there is no point finishing a fence that is about to fall over.
  2. Kill the moss and mould. OneRoof suggests spraying a moss and mould killer, leaving it for 48 hours, then scrubbing and rinsing.
  3. Wash the timber. A timber and deck wash helps. Both OneRoof and Resene steer away from the water blaster, because it can fluff the surface and mean extra sanding.
  4. Deal with old paint. Sand off flaking paint, feather the edges and spot-prime any bare patches.
  5. Let it dry. Stain tolerates slight dampness, Resene says, but dry is better for everything.

Near the coast, Resene's advice is to wash between coats to remove sea salt, which is worth remembering if you live anywhere with a salty breeze.

New timber: weather it or not?

New fences cause the most confusion. According to Resene, a new fence can be painted straight away because paint forms a film and does not have to penetrate. Stain does, so the answer for stain is to let the timber weather for about three to six months, or to wash it with a timber wash to open the grain sooner. If the timber is freshly treated and still damp or smelling strongly, wait. Resene adds that H3.2-treated timber can be left unpainted altogether; if you do paint it, use a primer and two topcoats.

Choosing your day

Paint and stain both prefer settled weather. Resene says to avoid painting in rain and when it is cold, with air and concrete temperatures above 10°C, and the same page notes hot weather can be a problem too. Direct sun on dark colours dries the finish too fast, so follow the shade around the section rather than painting the western fence at 2 pm in January. In Auckland, a dry spell in late spring or early autumn is usually the sweet spot. Dark colours can cause the timber to heat, and OneRoof recommends a heat-reflective formula for them to avoid warping.

Rough-sawn and tricky fences

Rough-sawn timber drinks product. OneRoof and Resene both say it can take 30 to 40 per cent more paint than smooth boards, so buy a little extra and do not be surprised if the first coat disappears. Corrugated iron needs a different approach: wash with a roof wash and a stiff brush, rinse, dry, then prime before painting.

Tools

Looking after it afterwards

Finishing the last paling is not the end of the job. A fence is the hardest-working vertical surface in the garden, catching sun on one side and splash and soil on the other, so it pays to look it over each autumn. Check the base of the palings where they meet the ground, touch up any chips before water gets in, and watch for mould returning on the shady side.

A quick spray with a cleaning product once or twice a year keeps the surface clear of the green growth that undoes good work, says OneRoof. Cheap paint, it adds, usually costs more in the long run because it needs more coats and an earlier repaint. Plantings against the fence matter too: keep climbers and shrubs trimmed back so air can move and the timber can dry.

Sources

Backyard Notebook: seasonal notes on Auckland gardens and sections, written from public sources like DOC, MPI and Auckland Council. General information only.